Installation Guide

Brake, fuel and electrical lines may need to be loosened or
repositioned to provide clearance for new hardware. Some
models require modification or removal of heat shields. On
short bed models, check for adequate turning clearance
between the front of all trailers and the truck cab. On two-
wheel drive trucks a clearance check must be performed
when the truck is loaded and unloaded to verify the inverted
ball will not interfere with the top of the differential.
Vehicle performance (braking, handling, acceleration,
turning radius) can be drastically affected by the trailer.
Allow additional time / space for stopping, changing lanes,
passing and turning.
DOUBLE LOCK GOOSENECK HITCH
WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY
INSTALLATION INSTRUCTIONS
WARNINGS
PARTS LIST
Item# Qty Description
1 1 Gooseneck center section
2 1 Center locator / trim shield
3 1 Rubber cover
4 1 Gooseneck ball, 2 5/16"
5 1 Handle assembly
6 1 Chrome ring, 3 3/4" x 3/4"
7 1 Cast lock pin
8 1 Compression spring, 7 1/2 lbs.
9 1 U-shaped edging, 1/3"
10 2 U-bolt, 5/8"
11 4 U-bolt spring
12 4 Nylock nut, 5/8"
13 8 USS washer, 5/8"
14 2 Washer, 3/8"
15 1 Hex head flange screw, 30mm
16 1 Nylock hex nut, M5
17 3 Flat head cap screw, 20mm
Safety glasses Drill bit, 3/16"
Ear protection Hole saw, 4" & 5/8"
Ratchet Allen wrench, #3
Socket, 8mm, 15/16" Cutting fluid
End wrench, 8mm Rust inhibitor
Drill
5
8
9
15
1
13
11
14
16
12
7
17
2
6
3
4
10
Figure 1
Keep gooseneck ball, cylinder and trailer coupler lubricated
regularly. Use silicone spray or equivalent to prevent wear / rust.
Keep hitch assembly and trailer coupler free of dirt and
other foreign debris. Periodically check the gooseneck hitch
to ensure that all fasteners are tight and that all structural
components are sound.
When the gooseneck ball is in the inverted position insert
the supplied rubber hole cover to keep out dirt and debris.
TOOLS LIST
MAINTENANCE
PAGE 1 • 60619-INS-RA • 1.800.798.0813 • NEED ASSISTANCE? • CURTMFG.COM