Installation Guide

Figure 2

Figure 1

60691 safety chain loops shown properly installed

Always install both safety chain loops in rear-most under-bed mounts

Periodically check all gooseneck components to ensure that

fasteners are tight and that structural components are sound.

Vehicle performance, such as braking, handling,

acceleration and turning radius, can be drastically

affected by the trailer. Allow additional time and space

for stopping, changing lanes, passing and turning.

Do not tow more than one trailer at a time.

This may cause loss of control.

Severe bumps can damage your towing system.

Avoid or drive slowly over rough terrain.

CURT Manufacturing, LLC, warrants this product to be free

of defects in material and/or workmanship at the time of

retail purchase by the original purchaser. If the product is

found to be defective, CURT Manufacturing, LLC, may repair

or replace the product, at their option, when the product

is returned, prepaid, with proof of purchase. Alteration to,

misuse of, or improper installation of this product voids the

warranty. CURT Manufacturing, LLC's liability is limited to

repair or replacement of products found to be defective, and

specifically excludes liability for incidental or consequential

loss or damage.

WARNINGS

WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER S RECOMMENDED TOWING CAPACITY

INSTALLATION INSTRUCTIONS

CHEVROLET

GMC OEM-COMPATIBLE

SAFETY CHAIN ANCHORS

PARTS LIST

Item# Qty Description

1 2 Safety chain anchor

2 2 10mm pin

3 2 5mm lynch pin

Under-bed mount

Safety chain

anchor

60629 gooseneck ball

Truck bed

PAGE 1 • 60691-INS-RA • 1.800.798.0813 • NEED ASSISTANCE? • CURTMFG.COM

PAGE 1
INSTALLATION INSTRUCTIONS WARNING: NEVER EXCEED YOUR VEHICLE MANUFACTURER S RECOMMENDED TOWING CAPACITY CHEVROLET / GMC OEM-COMPATIBLE SAFETY CHAIN ANCHORS 3 2 PARTS LIST Item# Qty Description 1 2 Safety chain anchor 2 2 10mm pin 3 2 5mm lynch pin 1 Figure 1 WARNINGS 60629 gooseneck ball Safety chain anchor Periodically check all gooseneck components to ensure that fasteners are tight and that structural components are sound.
PAGE 2
OPERATION MAINTENANCE Step 1 Align safety chain anchor with the rear-most under-bed mount on both sides. See figure 3. Note: Always install both safety chain anchors in the rear-most under-bed mounts. Keep the 60691 safety chain anchor pins lubricated. Use silicone spray or equivalent to prevent wear and rust. Keep the anchor and under-bed truck mounts free of dirt and other foreign debris. Step 2 Lower safety chain anchor into under-bed mount and rotate 90°. See figures 3 and 4.