Installation Guide

FIGURE 3
FIGURE 2
FORD SUPERDUTY GOOSENECK SUBKIT
**DO NOT EXCEED RECOMMENDED VEHICLE TOWING WEIGHT!**
60700 (60610 & 60651)
PAGE 2 OF 5
WARNING!! BRAKE, FUEL, AND ELECTRICAL LINES MAY NEED TO BE LOOSENED OR REPOSITIONED TO PROVIDE CLEARANCE FOR NEW HARDWARE. ALL
MODELS REQUIRE MODIFICATION OR REMOVAL OF HEAT SHIELDS. ON SHORT BED MODELS, CHECK FOR ADEQUATE TURNING CLEARANCE
BETWEEN THE FRONT OF ALL TRAILERS AND THE TRUCK CAB. ON TWO WHEEL DRIVE TRUCKS A CLEARANCE CHECK MUST BE PERFORMED
WHEN TRUCK IS LOADED AND UNLOADED TO VERIFY THE INVERTED BALL WILL NOT INTERFERE WITH THE TOP OF THE DIFFERENTIAL
PERIODICALLY CHECK THIS GOOSENECK HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
CURT Manufacturing LLC., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be
defective, CURT Manufacturing LLC., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper
installation of this product voids the warranty. CURT Manufacturing LLC.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for
incidental or consequential loss or damage.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.Regulation V-5 and SAE J684.
60610 CENTER SECTION
B
D
C
A
1
6
5
4
3
2
60610 TOP PLATE
TRUCK BED HEAT SHIELD
TRUCK BED
10
9
8
9
11
SUPPLIED FOR MODELS
WITHOUT FACTORY PLATE
(BOTH SIDES)
INSERT 66155 RUBBER PLUG INTO
GOOSENECK WHEN NOT IN USE
(INCLUDED WITH 60610)
REFER TO 60629 FOR INSTALLATION AND
OPERATION OF GOOSENECK BALL
(INCLUDED WITH 60610)
PASSENGER SIDE FRAME RAIL
DRIVER SIDE
FRAME RAIL