Owners manual

INSTALLATION CHECK
Connect the trailer to the hitch ball. Check clearance. You should have about 6" clearance
between bottom of trailer overhang and top of bed sides. Verify clearance between the
vehicle, and the trailer at all corner locations.
MAINTENANCE
1. Keep hitch ball greased regularly. Use wheel bearing grease to prevent wear and rust.
2. Keep hitch assembly free of dirt and other foreign matter.
3. Check tightness on all nuts and bolts before each use. Also check for excessive wear.
4. Check for ball wear before each use. Do not tow trailer with worn or damaged parts.
Thank You For Patronizing an American Company.
See us at a local dealer for all of your
hitch and trailer supplies.
PAGE 4
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
C-10 INSTALLATION INSTRUCTIONS
11/26/2007
5. Using the SAE grade 5, 5/8" carriage bolts, nuts
and lockwashers, attach the hitch ball assembly
and the frame structure support to accommodate
corrugation in pickup bed.
Truck Bed
5/8" Carriage Bolts
Center of Bed
Hitch Ball Assembly
1/2" Bolts
Frame Support Structure
(Not Included)
Frame Brackets
(Not Included)
Truck Frame
FIGURE 8
6. Tighten to 115 lb-ft. torque.
7. Fabricate four 3/8" x 2" steel frame brackets to fit
your particular truck.
8. Attach frame brackets to frame support structure
and truck frame using SAE grade 5, 5/8" hex bolts,
nuts, and lockwashers.
9. Tighten to 115 lb-ft. torque.
WARNING: Do not weld brackets to frame, welding
will not provide the strength needed for towing.
PARTS LIST:
(1) C-10 Flat Plate Hitchball
(6) 5/8-11 x 2 1/2" carriage bolts
(6) 5/8-11 flange nuts
(1) U-bolt kit (sold seperately)