Owners manual

ManualsBrandsCurt ManualsAutomotiveCURT 61301 Gooseneck Hitch Folding Ball Install Kit

61301

Curt Manufacturing Inc., warrants this product to be free of defects in material or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,

Curt Manufacturing Inc., may repair or replace the product, at their option,when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of

this product voids the warrant. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or

consequential loss or damage.

PAGE 1

C-52 TOP PLATE

HALF MOON SPACER

Shim bolts as needed between

C-52 and truck bed and/or

between truck bed and crossarms

at all bolt locations

CROSSARM FLANGE

TRUCK BED

CROSS ARM

C-52 CUT OUT

C-52 DRILLING TEMPLATE

SHIM BOLTS TO PREVENT TRUCK BED RIBS FROM COLLAPSING

SHOWN WITH C-52

INSTALLED

(NOT INCLUDED IN SUBKIT)

DRILL 1/8" PILOT

HOLE THROUGH BED

AT EACH MOUNTING

LOCATION

HALF MOON SPACERS

TUBE SPACER

30,000 LBS GTW GOOSENECK KIT

2011-CURRENT CHEVROLET / GMC 3/4 TON HD AND 1 TON

LONG BED

SHORT BED

LONG BED

Summary of content (3 pages)

PAGE 1
61301 2011-CURRENT CHEVROLET / GMC 3/4 TON HD AND 1 TON 30,000 LBS GTW GOOSENECK KIT HALF MOON SPACERS 3 2 6 5 DRILL 1/8" PILOT HOLE THROUGH BED AT EACH MOUNTING LOCATION 1 TUBE SPACER SHOWN WITH C-52 INSTALLED (NOT INCLUDED IN SUBKIT) SHORT BED LONG BED 4 LONG BED SHORT BED C-52 DRILLING TEMPLATE CROSS ARM C-52 TOP PLATE TRUCK BED HALF MOON SPACER Shim bolts as needed between C-52 and truck bed and/or between truck bed and crossarms at all bolt locations C-52 CUT OUT CROSSARM FLANGE SHIM
PAGE 2
61301 2011-CURRENT CHEVROLET / GMC 3/4 TON HD AND 1 TON 30,000 LBS GTW GOOSENECK KIT 12/26/2012 WARNING!! INSTALLATION STEPS 1. Remove spare tire for ease of installation. BRAKE, FUEL, AND ELECTRICAL LINES MAY NEED TO BE LOOSENED OR REPOSITIONED TO PROVIDE CLEARANCE FOR NEW HARDWARE. ALL MODELS REQUIRE MODIFICATION OR REMOVAL OF HEAT SHIELDS 2. Trim out heat shields between the bed supports on the passenger side of the vehicle. 3.
PAGE 3
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.*** CAB TO TRAILER CLEARANCE **REMOVAL OF REAR WINDOW ACCESSORIES MAY BE REQUIRED.** COUPLER OVERHANG TRAILER 4 in (W) 96 in COUPLER ***GENERALLY, TAPERED NOSE TRAILERS ADHERE TO THE FOLLOWING DESIGNS:*** 8 FT. WIDE TRAILERS TAPER TO 6 FT. AT THE COUPLER. 7 FT. WIDE TRAILERS TAPER TO 5 FT. AT THE COUPLER.