Owners manual

GROSS LOAD CAPACITY WHEN USED AS A WEIGHT CARRYING HITCH: LBS. TRAILER WEIGHT & LBS. TONGUE WEIGHT.
***DO NOT EXCEED VEHICLE MANUFACTURER'S RECOMMENDED TOWING CAPACITY.***
HITCH WEIGHT: LBS.
INSTALL TIME:
MINUTES
INSTALL NOTES:
INSTALLATION STEPS
PERIODICALLY CHECK THIS RECEIVER HITCH TO ENSURE THAT ALL FASTENERS
ARE TIGHT AND THAT ALL STRUCTURAL COMPONENTS ARE SOUND.
Curt Manufacturing Inc., warrants this product to be free of defects in material and/or workmanship at the time of retail purchase by the original purchaser. If the product is found to be defective,
Curt Manufacturing Inc., may repair or replace the product, at their option, when the product is returned, prepaid, with proof of purchase. Alteration to, misuse of, or improper installation of
this product voids the warranty. Curt Manufacturing Inc.'s liability is limited to repair or replacement of products found to be defective, and specifically excludes liability for incidental or
consequential loss or damage.
30,000 6,000
71.2
60
GOOSENECK FLAT PLATE
5/16/2008
C-55
1) The hitch must be centered between the sides of the truck and about 2"-6" in front of the rear
axle for proper weight distribution.
2) (6) 5/8" grade 5 bolts are recommended to fasten plate to truck frame.
NOTE: - Shims should be used to accommodate corrugation in pickup bed.
- When exceeding 20,000 gross trailer weight, a bed floor support should be fabricated and
installed to prevent the bed floor from collapsing.
- Hardware not included.
- Mounting holes must be drilled by installer.
DRILLING REQUIRED