Specifications

Curtis 1310 Manual, Rev. B
3
1 6 F E B R U A R Y 2 0 0 8 D R A F T
2 — INSTALLATION & WIRING
2
Fig. 2 Mounting
dimensions, Curtis 1310
vehicle system controller.
Dimensions in millimeters.
INSTALLATION AND WIRING
MOUNTING THE CONTROLLER
The outline and mounting hole dimensions for the 1310 controller are shown in
Figure 2. It is recommended that the controller be fastened securely to a clean,
flat metal surface with four #8 or M4 screws, using the holes provided. Care
should be taken to prevent water from splashing or resting on the connector
area. If possible, the controller should be mounted with the connector area fac-
ing downward and guarded from water and dust-born contaminants which
can degrade the electrical connections.
☞