Instruction manual

23 | Page
Copyright © 2009 Curtis Dyna-Fog, LTD.
DISPENSING FOG
WARNING
IF YOUR FLOW RATE REQUIRED TO ACHIEVE A "DRY" FOG IS GREATER
THAN THE AVERAGE FLOW RATE GIVEN IN TABLES 1 AND 2, FOGGING
TIME FOR THE ENCLOSED SPACE WILL BE DIFFERENT THAN THE TIME
SHOWN. (SEE SECTION ON PREVIOUS PAGE TO DETERMINE FOGGING
TIME.)
IT SHOULD ALSO BE NOTED THAT TABLES 1 AND 2 ARE BASED ON A
FLOW RATE OF 2.3 GPH (8.9 LT. /HR.) OR 5 OZ./MIN, (150 ML./MIN.) "DRY-
FOG" AS SHOWN.
1. If the engine is running, stop the engine and wait 15 seconds for pressure in
the Formulation Tank to escape.
CAUTION
Remove tank cap slowly
2. Rotate the Formulation Tank Cap fully counterclockwise (CCW) and remove it
from the formulation tank neck.
3. Place an appropriate amount of formulation in the formulation tank.
NOTE
It is a good idea to put only as much formulation in the tank as is necessary to do
a particular job. This helps to ensure that the formulation tank will be empty when
the fogging job is finished.