Instruction manual

31 | Page

INSTALLING AIR/FOG PLENUM

INSTRUCTIONS:

1. Loosen clamp of Air/Fog Plenum and slide assembly over end of Long Air

Duct.

2. Position Air/Fog Plenum so that the outer edge is approximately 2 in. (51

mm) from the edge of Long Air Duct.

3. Tighten clamp until snug.

WARNING

DO NOT over tighten clamp. Doing so can damage the Long Air Duct and can

cause further damage to the machine.

The Air Plenum enables an increase in

air flow to mix with the fog cloud. This

effect promotes a “billowing of the fog”.

This is extremely useful for fogging into

dense vegetation and enclosed areas

(i.e. buildings, sewer pipes, drains,

etc…)