Instruction manual

32 | Page

PREVENTATIVE MAINTENANCE

NOTE

A successful maintenance program begins after the first use of the machine and

not after the machine has ceased to function. Numbers in parentheses refer to

the identification numbers in the Parts identification Section.

AFTER EACH USE

If the machine will be left idle for more than one (1) hour, flush the system as

follows to avoid frozen valves and plugged lines resulting from formulation

residues.

FLUSH THE FORMULATION SYSTEM

1. Drain the Formulation Tank.

CAUTION:

Store the formulation properly. See the cautions under clean up.

2. Pour one pint of kerosene, No. 2 Fuel Oil or Diesel Fuel into the Formulation

Tank and thoroughly mix it inside the tank.

3. Start the engine in accordance with the OPERATION section and fog out all of

the liquid in the tank.

WARNING

ALL CAUTIONS AND WARNINGS APPLICABLE TO OPERATION AND

FOGGING ARE APPLICABLE TO THIS FLUSHING PROCEDURE.

INSPECT FOR FORMULATION RESIDUES

Examine the Formulation Tank and system for residues. If deposits are building

up, increase the amount of flushing liquid that is fogged after each use.