Instruction manual

34 | Page
Copyright © 2009 Curtis Dyna-Fog, LTD.
AFTER EVERY EIGHT (8) HOURS OPERATION
Clean the Formulation Filters
1. If so equipped, remove the FORMULATION FILTER located in the tank neck. Clean with
detergent and water.
ANTECHAMBER CLEANOUT DIAGRAM
Figure 5
2. If the filter has deposits that soap and water will not remove, clean it using an
automotive carburetor cleaner.
3. Thoroughly dry the filter and re-install.
CAUTION
Do not operate the system without the formulation filter installed. Extensive
damage to the system may occur due to clogging of lines and orifices.