Service manual

2
1.BrewershouldbeON(Conrmatthereartoggleswitch).TheLCDscreenshouldreadReadytoBrew.
2.Placeanemptysatelliteserveronthewarmerdeck,underthebrewconeandtouchthewarmericontoPreheatthesatellite.
COFFEE BREWING INSTRUCTIONS
6. Startthebrewcyclebyholdyournger
on the desired brew icon. As soon as
youheartheclickofthebrewvalve,the
brew cycle has started and you can lift
yournger.
Brew Code: Youmayndthatwhenabrew
buttonispressed,akeypadappearsonthe
screen.Thisisabrewlock-outfeaturethat
5. Transferthelledbrewconetothe
brewer.
3. Placeanewpaperlterintothebrew
cone.
4. Fill the brew cone with the proper
amount of ground coffee.
WARNING – AVOIDSCALDING:REMOVETHEBREWCONECAREFULLY.Thebrewconecontainshotcoffeegrounds.
Thecoffeevesselisheavywhenfull.Takeprecautionstoavoiddroppingwhenmoving.
requires a code to be entered before a brew
will start. The default is OFF.
CAUTION: Whenenabled,assoonasyou
enter the brew code a brew cycle starts.
Refer to page 8 for information about setting
theBrewCode.
Duringthebrewcycle,ananimated1½
gallon satellite server icon will appear on the
screen and a brew timer will count down the
time remaining on the brew cycle.
Your Curtis G4/Gold Cup Series is Factory Pre-Set for Optimum Performance.
After connection to water and power; turn on the brewer at the rear toggle switch. You will hear a beep and the status lights will come on for a moment.
The screen will display . Next is displayed. Water will ll the tank (2-3 minutes depending on water ow rate).
When the proper level is reached will appear on the screen. It takes approximately 30 minutes to reach the set point temperature.
Control will display when temperature reaches the set point. The unit is now ready to brew.
MODEL NUMBER
CONTROL BD NUMBER
READY TO BREW
HEATING
FILLING