International INSTRUCTION MANUAL CD PLAYER WITH TURNTABLE ANDSTEREO RADIO RECEIVER RCD824

ManualsBrandsCurtis ManualsCD PlayerRCD824

CD PLAYER WITH TURNTABLE ANDSTEREO RADIO RECEIVER

RCD824

INSTRUCTION MANUAL

Summary of content (6 pages)

PAGE 1
CD PLAYER WITH TURNTABLE ANDSTEREO RADIO RECEIVER RCD824 INSTRUCTION MANUAL
PAGE 2
GRAPHICAL SYMBOLS EXPLANATION AND OUTDOOR USE OR WET LOCATION WARNING THE OPERATING INSTRUCTION SHALL ACCOMPANY THE ILLUSTRATION OF THE GRAPHICAL SYMBOLS MARKED ON THE APPLIANCE, AND AN EXPLANATION OF THEIR MEANING.
PAGE 3
IMPORTANT SAFETY INSTRUCTIONS 1. READ THESE INSTRUCTIONS 2. KEEP THESE INSTRUCTIONS 3. HEED ALL WARNINGS 4. FOLLOW ALL INSTRUCTIONS 5. DO NOT USE THIS APPARATUS NEAR WATER 6. CLEAN ONLY WITH A DRY CLOTH 7. DO NOT BLOCK ANY OF THE VENTILATION OPENINGS. INSTALL IN ACCORDANCE WITH THE MANUFACTURERS INSTRUCTIONS 8. DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS, HEAT REGISTERS, STOVES, OR OTHER APPARATUS (INCLUDING AMPLIFIERS) THAT PRODUCE HEAT. 9.
PAGE 4
LOCATION OF CONTROLS 1) 2) 3) 4) 5) 6) 7) 8) 9) 10) 11) 12) 13) 14) 15) 16) 17) 18) 19) 20) 21) 22) 23) 24) 25) 26) 27) 28) 29) DUST COVER DIAL POINTER LEFT SPEAKER LED DISPLAY MEMORY LED INDICATOR REMOTE SENSOR FM STEREO LED INDICATOR CD DOOR VOLUME KNOB X-BASS CONTROL BUTTON PROGRAM BUTTON REPEAT BUTTON RIGHT SPEAKER TUNING KNOB CD DOOR OPEN BUTTON CD STOP BUTTON RADIO BAND SELECTOR FUNCTION SELECTOR 3.
PAGE 5
FM & FM-STEREO RECEPTION z z SET THE RADIO BAND SELECTOR AT “ FM ” POSITION. PROGRAMS ARE RECEIVED IN MONO MODE. IN PARTICULAR WHEN STEREO SIGNAL ARE WEAK. IT IS PREFERABLE TO RECEIVE THE PROGRAM IN MONO. SET THE RADIO BAND SELECTOR AT “FM-ST” POSITION FOR RECEIVING STEREO PROGRAMS. THE FM-STEREO LED INDICATOR WILL LIGHT UP TO SHOW FM STEREO PROGRAM IS RECEIVING. HINTS FOR BEST RECEPTION:- AM : THE RECEIVER HAS A BUILT-IN AM BAR ANTENNA.
PAGE 6
PHONO NOTED: - REMOVE THE STYLUS PROTECTOR. BE SURE THAT THE TONE ARM IS BEING DETACHED FROM THE TONE ARM REST BEFORE OPERATING AND RE-SECURED AGAIN AFTERWARDS. 1. 2. SELECT TO “ PHONO ” FUNCTION. SET THE SPEED SELECTOR TO THE PROPER POSITION DEPENDING ON THE RECORD TO BE PLAYED. PLACE THE RECORD ON THE PLATTER (USE THE SPINDLE ADAPTOR IF REQUIRED). LIFT THE TONE ARM FROM THE REST AND SLOWLY MOVE IT TO THE RECORD SIDE. THE PLATTER WILL START TO ROTATE.