Installation Guide

AquaMix®/TDS223
1 Product Name
AquaMix®GroutHazeCleanUp
2 Manufacturer
Custom Building Products
Technical Services
10400 Pioneer Boulevard, Unit 3
Santa Fe Springs, CA 90670
Customer Support: 800-272-8786
Technical Services: 800-282-8786
Fax: [phone]
Email: [e-mail]
custombuildingproducts.com
3 Product Description
A safe and effective concentrated cleaner that is added to the grout
cleanup water for removal of cementitious grout haze and latex
additive film from tile during the grout cleanup process. It may also be
used full-strength to remove light grout residue within the first 10 days
after grouting.
Key Features
Add to clean-up water
Removes grout haze and latex additive film
Non-acidic formula
Uses
Unpolished natural stone (such as granite, limestone, marble, slate,
and travertine), polished granite, ceramic, porcelain, quarry, Saltillo,
terra-cotta, cement pavers, masonry surfaces, and other stone and tile
surfaces
Limitations to the Product
Do not allow product to come in contact with any non-recommended
surface
Do not use on polished marble or any other acid-sensitive tile or stone
Do not use excessive amounts of water during cleanup process as
grout pigment may be washed out
4 Technical Data
Environmental Consideration
Complies with all Federal EPA and SCAQMD standards for VOC.
5 Instructions
Application of Product
USE CHEMICAL-RESISTANT GLOVES, such as nitrile, when
handling product.
DURING GROUT CLEANUP: Read entire label before using. Perform
grout cleanup per grout manufacturer's instructions. Mix 3 to 5 oz (90
to 147 mL) of Grout Haze Clean-Up per gallon (3.8 L) of water. Wet a
grout sponge or terry cloth towel with the cleaning solution, wring out
excess liquid. Wipe diagonally across the tile. Repeat steps 4 and 5
every 10 to 15 ft (.9 M to 1.3 M) or as necessary. Remove residual
cleaning solution using a clean grout sponge or terry cloth towel
dampened with clean water only.
AFTER GROUT CLEANUP WITHIN 10 DAYS OF GROUTING: Use full
strength if grout haze was not completely removed during grout
cleanup. Apply directly to surface and agitate with white nylon scrub
pad or brush. Allow product to dwell for 5 to 10 minutes for stubborn
areas or heavier grout residue. Rinse with clean water to remove
residual cleaning solution.
Cleaning of equipment
Clean tools with water before material dries.
Health Precautions
MAY BE HARMFUL IF SWALLOWED. MAY IRRITATE EYES AND SKIN.
Wear skin and eye protection. Contains EDTA acid, sodium
tripolyphosphate, trisodium citrate dihydrate, and Beta-Alanine, N -(2-
carboxyethyl)-N-(2-ethylhexyl)-monosodium salt. If in eyes, flush with
water for at least 15 minutes. If on skin, wash with soap and water. If
irritation persists, seek medical attention. If swallowed, DO NOT induce
vomiting, seek medical attention.
6 Availability & Cost
Location Item Code Size Package
USA 010461 1 Pint (473 ml) Bottle
Canada C010461 1 Pint (473 ml) Bottle
7 Product Warranty
Custom®BuildingProductswarrantstotheoriginalconsumer
purchaser that its product shall be free from defects in material and
workmanship under normal and proper usage for a period of one year
followingthedateoforiginalpurchase.Custom's®soleliabilityunder
this warranty shall be limited to the replacement of the product. Some
states, countries or territories do not allow the exclusion or limitation
of incidental or consequential damages, so the above limitation or
exclusion may not apply to you. This warranty will not extend to any
product which has been modified in any way or which has not been
usedinaccordancewithCustom's®printedinstructions.Custom®
makes no other warranties either expressed or implied. This warranty
gives you specific legal rights, and you may have other rights that vary
from state to state or from one country/territory to another. This
warranty is not transferrable.
8 Product Maintenance
Properly applied product requires no special maintenance.
AquaMix®GroutHazeCleanUp
Published Date: 12/10/2015