Installation Guide

AquaMix®HighGlossSealer/TDS161
1 Product Name
AquaMix®HighGlossSealer
2 Manufacturer
Custom Building Products
Technical Services
10400 Pioneer Boulevard, Unit 3
Santa Fe Springs, CA 90670
Customer Support: 800-272-8786
Technical Services: 800-282-8786
Fax: [phone]
Email: [e-mail]
custombuildingproducts.com
3 Product Description
A specially formulated water-based sealer of acrylic polymers that
provides both a stain-resistant surface seal and a durable high-sheen
finish, eliminating the need for two products. May also be used as a
pre-grouting sealer. Allows moisture vapor transmission and is
unaffected by ultra-violet light.
Key Features
One step sealer & finish
Excellent stain protection
High-gloss finish
Uses
For clay pavers including Saltillo, terra-cotta and adobe, cement tile,
quarry, slate and sandstone.
For interior applications only.
Benefits of Product in the Installation
Excellent stain resistance to household contaminants (CTI-072)
Excellent mar resistance
High-gloss sheen
Limitations to the Product
Not recommended for use on smooth glazed ceramic or porcelain tile,
as surface must be rough-textured to ensure adequate bonding.
Do not allow product to come in contact with any non-recommended
surface.
Not recommended for use in or around pools, showers or areas
subject to standing water.
Not recommended for use on countertops.
Keep surface clean and dry to reduce possibility of slip-fall accidents.
4 Technical Data
Environmental Consideration
Complies with all Federal EPA and SCAQMD standards for VOC
5 Instructions
General Surface Prep
USE CHEMICAL-RESISTANT GLOVES, such as nitrile, when
handling product.
Surface should be dry, clean and free of waxes, sealers, or finishes.
Do not apply directly over silicone sealers, oil or wax based finishes.
AquaMix®Sealer&CoatingRemoverwillstripthesurfaceand
remove wax or old acrylic finishes. Place a few drops of water on
various tiles. If water doesn't penetrate, additional removal is
necessary. New installations need to be dry at least 48 hours before
application. Clay and Saltillo tile may require extended drying time
depending on temperature and humidity. Make sure the tiles are
completely dry before application. Test product in an inconspicuous
area to ensure desirable results.
Exterior applications must meet moisture conditions - read CUSTOM
Technical Bulletin 49 for details.
Application of Product
Read entire label before using. For new installations sealer can be
applied as soon as 48 hours after grouting. Surface must be clean, dry
and free of existing sealers and coatings. Apply 2-3 coats of sealer
with a clean dense sponge, brush or paint pad applicator in thin, even
coats. Allow 30 minutes drying time between coats. Avoid puddling.
Pre-Grouting Application
Apply over clean stone or tile a minimum of 2 hours prior to grouting -
follow application procedures above.
Drying Time
Ready for surface traffic 6 hours after final coat. Keep area dry for at
least 12 hours. Achieves a full cure in 24 hours.
Cleaning of equipment
Clean tools with mineral spirits immediately after use.
Storage
Close container tightly after each use
Store in original container only
Storeandusebetweentemperaturesof45°Fto85°F(7°Cto29°C)
Dispose of residue or any unused leftover product in accordance with
applicable federal, state, and local requirements
AquaMix®HighGlossSealer
Published Date: 5/16/2016