MSDS

Conforms to OSHA HazCom 2012 Standard and WHMIS
SAFETY DATA SHEET
Page 4 of 10
Peel & Stick Primer Print Date: 29-May-14
5.4 SPECIAL PROTECTIVE EQUIPMENT AND PRECAUTIONS FOR FIRE-FIGHTERS
Keep upwind of fire. Wear full fire fighting turn-out gear (full Bunker gear) and respiratory protection
(SCBA).
Section 6: ACCIDENTAL RELEASE MEASURES
6.1 PERSONAL PRECAUTIONS, PROTECTIVE EQUIPMENT, AND EMERGENCY PROCEDURES
Use personal protection recommended in Section 8. Isolate the hazard area and deny entry to
unnecessary and unprotected personnel.
6.2 METHODS AND MATERIALS FOR CONTAINMENT AND CLEANING UP
Methods for Containment:
Contain and/or absorb spill with inert material (e.g. sand,
vermiculite), then place in a suitable container. Prevent entry into
sewage and waterways.
Methods for Cleaning-Up:
Scoop up inert material used to absorb and contain the spill. Rinse
off with water, but do NOT let rinse water enter into sewage and
waterways. Dispose of unwanted material properly in accordance
with all local, regional, national and international regulations.
Section 7: HANDLING AND STORAGE
7.1 PRECAUTIONS FOR SAFE HANDLING
Handling:
Use in well-ventilated areas. Wear chemical resistant gloves and
eye protection. Do not mix with other chemical products. Do not get
in eyes. Do not get on skin or clothing. Do not breathe fumes. Do
not take internally.
General Hygiene Advice:
Use good industrial hygiene practices and wear recommended
personal protection.
7.2 CONDITIONS FOR SAFE STORAGE, INCLUDING ANY INCOMPATIBILITIES
Storage:
Keep out of the reach of children. Keep container tightly closed.
Store between +5°C and +35°C protected from frost and direct
sunlight. Keep containers closed when not in use.
Section 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1 CONTROL PARAMETERS
Exposure Guidelines:
Not applicable.
8.2 EXPOSURE CONTROLS