MSDS

M A T E R I A L S A F E T Y D A T A S H E E T
Page 3 of 5
ReliaBond Ceramic Tile Adhesive
6. Accidental Release Measures
Clean up spill immediately. Cover with absorbent to contain. Collect and dispose. Use appropriate containers to avoid
environmental contamination. Avoid runoff to waterways and sewers. Avoid release to the environment.
Use appropriate personal protective equipment (PPE).
7. Handling And Storage
Handling And Storage Precautions
Store in cool, dry areas away from sunlight, heat and heat sources. Protect from freezing.
Work/Hygienic Practices
Wash thoroughly with soap and water after handling. Use good personal hygiene. Observe good housekeeping
practices.
8. Exposure Controls/Personal Protection
Eye/Face Protection
Safety glasses with side shields or goggles recommended.
Skin Protection
Chemical-resistant gloves.
Respiratory Protection
General room ventilation is normally adequate. .In case of inadequate ventilation, use NIOSH-approved respirator.
Other/General Protection
General ventilation is usually sufficient. Fan or other device maybe needed if used in small and enclosed areas.
Ingredient(s) - Exposure Limits
ETHYLENE GLYCOL
OSHA VPEL - 50.000 ppm - Ceiling
ACGIH TLV - 100.000 mg /m3 Ceiling as aerosol
MINERAL SPIRITS - STODDARD SOLVENT
ACGIH TLV-TWA 100 ppm
OSHA PEL-TWA 500 ppm
OSHA VPEL - TWA 100 ppm
Calcium Carbonate
OSHA - PEL - TWA - 15mg/m3
Niosh - REL 10 mg/m3
ACGIH- TLV - 10 mg/m3
OSHA - PEL - TWA - 5 mg/m3
Adequate clothing to prevent skin contact.
9. Physical And Chemical Properties
Appearance
White paste
Odor
Mild acrylic odor.
Chemical Type: Mixture
Physical State: Liquid
Boiling Point: 212 °F
Specific Gravity: 1.6
Vapor Density: HEAVIER THAN AIR
S o l u b i l i t y : Dilutable in water
Evaporation Rate: Slower than ether