SDS

Conforms to OSHA HazCom 2012 Standard and WHMIS 2015
SAFETY DATA SHEET
Page 5 of 11
SpeedSet™ Fortified Thin-Set Mortar
7.2 CONDITIONS FOR SAFE STORAGE, INCLUDING ANY INCOMPATIBILITIES
Storage:
Keep out of the reach of children. Store locked up. Keep container
tightly closed. Store at room temperature and keep containers
closed when not in use. Keep dry until use.
Section 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1 CONTROL PARAMETER
Exposure Guidelines:
Occupational Exposure Limits
Chemical Name
OSHA-PEL
ACGIH-TLV
Crystalline Silica, Quartz
0.05 mg/m³
0.025 mg/m³ (Resp.)
Portland Cement
5 mg/m³ (Resp.)
15 mg/m³ (Total)
10 mg/m³ (Resp.)
Calcium Aluminate Cement
5 mg/m³ (Resp.)
15 mg/m³ (Total)
10 mg/m³ (Resp.)
8.2 EXPOSURE CONTROLS
Engineering Controls:
Use ventilation adequate to keep exposures (airborne levels of
dust, fume, vapor, etc.) below recommended exposure limits.
8.3 INDIVIDUAL PROTECTION MEASURES
8.3a. Personal Protective Equipment:
i. Eye/Face Protection: Wear approved eye/face protection [properly fitted dust- or splash-
proof chemical safety goggles/face (face shield)]
ii.Skin Protection:
1. Hand Protection: Wear impervious gloves, such as nitrile.
2. Body Protection: Wear suitable protective clothing.
iii. Respiratory Protection: A NIOSH approved respirator or filtering face piece, such as N95,
is recommended in poorly ventilated areas or when permissible exposure limits may be
exceeded. Respirators should be selected by and used under the direction of a trained
health and safety professional following requirements found in OSHA’s respirator standard
(29 CFR 1910.134) and ANSI’s standard for respiratory protection (Z88.2).
iv. General Health and Safety Measures: Handle according to established industrial hygiene
and safety practices.
Section 9: PHYSICAL AND CHEMICAL PROPERTIES
Appearance (physical state, color, etc.):
Solid Powder(Gray Or White)
Odor:
Characteristic
Odor Threshold:
Not Available