TDS

SimpleFix®PreMixedAdhesive&Grout/TDS180
1 Product Name
SimpleFix®PreMixedAdhesive&Grout
2 Manufacturer
Custom Building Products
Technical Services
10400 Pioneer Boulevard, Unit 3
Santa Fe Springs, CA 90670
Customer Support: 800-272-8786
Technical Services: 800-282-8786
Fax: [phone]
Email: [e-mail]
custombuildingproducts.com
3 Product Description
Ready-to-use product bonds and grouts ceramic floor and wall tile.
Crack, shrink and stain resistant. Great for repairs and small jobs. For
information on use in larger installations, please call Custom technical
services.
Key Features
Ready to use
No mixing, No mess
Stain resistant
Great for repairs
For joints 1/16" to 3/8"
Suitable Tile Types
Bonds and grouts ceramic tile
Suitable Substrates
For interior use only
Suitable for wet areas such as tub surrounds and shower walls.
Concrete
Plaster, gypsum wallboard (dry areas)
WonderBoard®,cementbackerboards
Exterior Grade Plywood
Limitations to the Product
Do not bond tile directly to lightweight concrete, gypsum surfaces,
hardwood, Luan plywood, particle board, parquet, cushion or sponge-
back vinyl flooring, cutback adhesive, metal, fiberglass, plastic or OSB
panels. Contact Technical Services.
Do not use apply over vinyl flooring or plastic laminates.
Do not use on shower floors or areas exposed to prolonged water
exposure or steam.
Do not use to install fixtures, stone tile, porcelain, saltillo pavers or
glass tile.
Do not use to install backerboards to subfloors, over a waterproof
membrane or to install heating mats or coils. We recommend using a
Custom®fortifiedmortar.
Do not use more than is necessary to bond tile. If floor is uneven use a
LevelQuik® or LevelLite®SelfLevelingUnderlayment.
Not for use in movement joints or changes of plane in the tile
installation. In these areas us an appropriate caulk or sealant such
as Commercial 100% Silicone Caulk or Polyblend®CeramicTileCaulk.
Packaging
1 quart (.946 L) pail
1 gallon (3.78 L) pail
4 Technical Data
Environmental Consideration
Custom®BuildingProductsiscommittedtoenvironmental
responsibility in both products produced and in manufacturing
practices.UseofthisproductcancontributetowardsLEED®v3
certification:
Up to 2 points towards MR Credit 5, Regional Materials
Upto1pointtowardsIEQCredit4.1,LowEmittingMaterials–
Adhesives & Sealants
5 Instructions
General Surface Prep
USE CHEMICAL-RESISTANT GLOVES, such as nitrile, when
handling product.
Surfaces must be structurally sound, clean, dry and free from grease,
oil, dirt, curing compounds, sealers, adhesives or any other
contaminant that would prevent a good bond. Concrete or plaster must
be fully cured for 28 days and accept water penetration. Concrete
must be free of efflorescence and not subject to hydrostatic pressure.
Plywood flooring must be structurally sound and meet all ANSI and
deflection requirements (no flex or movement). Surfaces and materials
shouldbemaintainedatatemperatureabove50°F(10°C)orbelow
100°F(38°C)for72hours.
Application of Product
As an Adhesive
SimpleFix®PreMixedAdhesive&Grout
Published Date: 3/30/2018