User manual

3. PRINTER FUNCTIONS

3-7

DPT100-B/I/BT

which was enabled at the moment of switching on

[Notes] • Same as hardware reset

• After the command has been transmitted, 1.5 seconds elapse before the printer is

enabled

[Default]

[Reference]

[Example] This can be useful during switching on in order to avoid the sending of false characters

during initialization by the master device.

]Ln[]Hn[14$B1$

[Name] Executes [n] dots line feed

[Format] ASCII ESC A nH nL

Hex 1B 41 nH nL

Decimal 27 65 nH nL

[Description] Executes [n] dots line feed.

[Notes]

[Default]

[Reference]

[Example]

nd...0dnm24$B1$

[Name] Sets and reads the communication BlueTooth parameters

[Format] ASCII ESC B m n d0... dn

Hex 1B 42 m n d0... dn

Decimale 27 66 m n d0... dn

[Range] 1 ≤ m ≤ 8

0 ≤ d0, dn ≤ 255

[Description] Sets and reads the parameters for BlueTooth communication ; m indicates wich

operation is selected as specified below :

mn noitarepO

161-1ehtsetirW emaNTB eulavretemarap

28-1ehtsetirW NIPTB eulavretemarap

ehtsetirW noitacitnehtuA eulavretemarap

4ehtsetirW eliforPhsuPtcejbO eulavretemarap

ehtsdaeR emaNTB eulavretemarap

6ehtsdaeR NIPTB eulavretemarap

7ehtsdaeR noitacitnehtuA eulavretemarap

8ehtsdaeR eliforPhsuPtcejbO eulavretemarap

• n specifies the lenght of the byte to receive and it’s depends by m value;

• d0...dn specifies the byte to store;

[Notes] • if 1 ≤ m ≤ 8 the $06 character (ACK) is returned; otherwise the $15 character (NACK) is

returned.

• It’s recommended to entered the PINs parameter value as decimal digits because some