Use and Care Guide

ManualsBrandsCustom Size Now by Levolor ManualsBlindsEFWCDD3606401D

Page 1 of 9 Trim&Go! Wood Blind Shortening Instructions

Levolor Cordless Wood Blind Shortening Instructions

The following are instructions to shorten Levolor Trim & Go cordless faux wood

blinds. To see a detailed video of this operation, visit our website at:

http://www.levolor.com/products/blinds/trimandgo/wood-blinds/

Necessary Tools:

Step 1: Install and lower the blind fully

Summary of content (9 pages)

PAGE 1
Levolor Cordless Wood Blind Shortening Instructions The following are instructions to shorten Levolor Trim & Go cordless faux wood blinds. To see a detailed video of this operation, visit our website at: http://www.levolor.
PAGE 2
Step 2: Remove the end caps in the bottom rail (if already installed) Slide out the slat in the bottom rail, exposing the inside of the rail Page 2 of 9 Trim&Go! Wood Blind Shortening Instructions
PAGE 3
Step 3: Select the slat even with (or slightly below) the window sill; this will be the new bottom slat Below the bottom slat, cut all the horizontal connector cords (repeat for all horizontal connector cords below the new bottom slat) NOTE: Be careful not to cut any vertical cords Page 3 of 9 Trim&Go! Wood Blind Shortening Instructions
PAGE 4
Step 4: Trim off all loop cord below the new bottom slat (repeat for all loop cords below the new bottom slat) Step 5: Remove all excess slats below your new bottom slat Page 4 of 9 Trim&Go! Wood Blind Shortening Instructions
PAGE 5
Step 6: Depress the lift button and slowly raise the bottom rail until it is touching the new bottom slat Step 7: From the open bottom side of the bottom rail pull each of the ladder cords downward as far as they will go Page 5 of 9 Trim&Go! Wood Blind Shortening Instructions
PAGE 6
Cut the metal eyelets from the ladder cords Step 8: Double check the desired length of the blind before any further cutting; then, trim all ladder cords 4 in.
PAGE 7
Step 9: Take the eyelets from the parts bag; working from inside the bottom rail, simultaneously thread both sides of the ladder cords through an eyelet (repeat for all ladder cords) Step 10: Slide the eyelets as far inside the bottom rail as possible and crimp tightly with the pliers (repeat for all ladder cords); trim excess ladder cord 2 in.
PAGE 8
Step 11: Tie double knots below the eyelets for extra security Step 12: Making sure all cords are tucked into the bottom rail, slide the bottom slat back into the bottomrail Page 8 of 9 Trim&Go! Wood Blind Shortening Instructions
PAGE 9
Finally, install the end caps Now enjoy your PERFECTLY sized blinds from Levolor! Page 9 of 9 Trim&Go! Wood Blind Shortening Instructions