User Manual

1. Place the back pad and the
sternum strap on a flat surface.
Make sure the Custom SLR logos
are facing forward.
2. Unbuckle the sternum strap.
3. Take the two Split Strap pads
and connect them to the top of
the sternum strap.
4. Take the Glide Strap
attachments and connect the
non-adjustable ends to the
bottom of the sternum strap.
5.Attach the remaining ends
of the Split Strap pads to the
top of the back pad.
6. Attach the adjustable ends of
the Glide Strap attachments to
the bottom of the back pad.
8. After adjusting the strap length to
fit comfortably, roll up the excess
strap and tuck it into the strap holder.
7. This is how the back pad
will look when properly connected.
For videos and additional
instructions visit
customslr.com/instructions
D UAL STRAP KIT
IN STRU CTIO N S