Specifications

A/C CONDENSER LOCATION

A roof mounted A/C condenser shall be installed centered on the cab forward of the raised roof against

the slope rise.

A/C COMPRESSOR

The air-conditioning compressor shall be a belt driven, engine mounted, open type compressor that shall

be capable of producing a minimum of 32,000 BTU at 1500 engine RPMs. The compressor shall utilize

R-134A refrigerant and PAG oil.

CAB INSULATION

The cab ceiling and walls shall include 1.00 inch thick foam insulation. The insulation shall act as a

barrier absorbing noise as well as assisting in sustaining the desired climate within the cab interior.

UNDER CAB INSULATION

The underside of the cab tunnel surrounding the engine shall be lined with multi-layer insulation,

engineered for application inside diesel engine compartments.

The insulation shall act as a noise barrier, absorbing noise thus keeping the decibel level in the cab well

within NFPA recommendations. As an additional benefit, the insulation shall assist in sustaining the

desired temperature within the cab interior.

INTERIOR TRIM FLOOR

The floor of the cab shall be covered with a multi-layer mat consisting of 0.25 inch thick sound absorbing

closed cell foam with a 0.06 inch thick non-slip vinyl surface with a pebble grain finish. The covering

shall be held in place by a pressure sensitive adhesive and aluminum trim molding. All exposed seams

shall be sealed with silicone caulk matching the color of the floor mat to reduce the chance of moisture

and debris retention.

REAR WALL INTERIOR TRIM

The rear wall of the cab shall be trimmed with vinyl.

HEADER TRIM

The cab interior shall feature header trim over the driver and officer dash constructed of 5052-H32

Marine Grade, 0.13 inch thick aluminum.

TRIM CENTER DASH

The main center dash area shall be constructed of 5052-H32 Marine Grade, 0.13 inch thick aluminum

plate. There shall be four (4) holes located on the top of the dash near each outer edge of the electrical

access cover for ventilation. The dash shall include cup holders and storage bins.