Specifications

23
TRIM LH DASH
The left hand dash shall be constructed of 5052-H32 Marine Grade, 0.13 inch thick aluminum plate for a
perfect fit around the instrument panel. For increased occupant protection the extreme duty left hand dash
utilizes patent pending break away technology to reduce rigidity in the event of a frontal crash. The left
hand dash shall offer lower vertical surface area to the left and right of the steering column to
accommodate control panels.
TRIM RH DASH
The right hand dash shall be constructed of 5052-H32 Marine Grade, 0.13 of an inch thick aluminum
plate and shall include a glove compartment with a hinged door and a Mobile Data Terminal (MDT)
provision. The glove compartment size will measure 14.00 inches wide X 6.38 inches high X 5.88 inches
deep. The MDT provision shall be provided above the glove compartment.
ENGINE TUNNEL TRIM
The cab engine tunnel shall be covered with a multi-layer mat consisting of 0.25 inch closed cell foam
with a 0.06 inch thick non-slip vinyl surface with a pebble grain finish. The mat shall be held in place by
pressure sensitive adhesive. The engine tunnel mat shall be trimmed with anodized aluminum stair nosing
trim for an aesthetically pleasing appearance.
ENGINE TUNNEL TRAY
There shall be a tray built the same size as the top of the engine tunnel with a one (1) inch lip all the way
around the tray. This tray shall be sprayed with Linex or equivalent. The tray shall be mounted to the top
of the engine tunnel with a one (1) inch between the tray and the top of the engine tunnel. This is to allow
wiring to be run under the tray and not drill holes through the engine tunnel
POWER POINT DASH MOUNT
The cab shall include three (3) 12 volt cigarette lighter type receptacles in the cab dash to provide a power
source for 12 volt electrical equipment. The receptacles shall be wired battery direct.
AUXILIARY POWER POINT COMPARTMENTS
The cab interior shall include one (1) 12 volt cigarette lighter type receptacle located in the glove
compartment within the right side dash. This receptacle shall provide a power source for 12 volt
electrical equipment.
STEP TRIM
Each cab entry door shall include a three step entry. The first step closest to the ground shall be
constructed of polished 5032 H32 aluminum Grip Strut® grating with angled outer corners. The step shall
feature a splash guard to reduce water and debris from splashing in to the step. The splash guard shall
have an opening on the outer edge to allow debris and water to flow through rather than becoming trapped
within the stepping surface. The lower step shall be mounted to a frame which is integral with the
construction of the cab for rigidity and strength. The middle step shall be integral with the cab
construction and shall be trimmed with a Flex-Tred
®
adhesive grit surface material.