Specifications

27
SEAT FORWARD FACING OUTER LOCATION JUMP
The crew area shall include two (2) forward facing self folding crew seats, which include one (1) located
outward on the left side rear wall and one (1) located outward on the right side rear wall. These seats
shall be non SCBA seats with three point seat belts. These seats shall fold out of the way when not in
use.
MDT SLIDE MOUNT
There shall be a Mobile data terminal mounting system installed. The MDT shall be accessible from the
officer’s seat while the officer is belted into his SCBA and seat belt. The MDT mount can be on slides or
swivel but shall not hinder getting in or out of the apparatus.
CAB FRONT UNDERSEAT STORAGE ACCESS
The left and right under seat storage areas shall have a solid aluminum hinged door with non-locking
latch.
SEAT COMPARTMENT DOOR FINISH
All under seat storage compartment access doors shall have a Zolatone #20-72 silver gray texture.
WINDSHIELD WIPER SYSTEM
The cab shall include a dual arm wiper system which shall clear the windshield of water, ice and debris.
There shall be two (2) windshield wipers which shall be affixed to a radial wet arm. The system shall
include a single motor which shall initiate the arm in which both the left hand and right hand windshield
wipers are attached, initiating a back and forth motion for each wiper. The wiper motor shall be activated
by an intermittent wiper control located within easy reach of the driver’s position.
ELECTRONIC WINDSHIELD FLUID LEVEL INDICATOR
The windshield washer fluid level shall be monitored electronically.
CAB DOOR HARDWARE
The cab entry doors shall be equipped with exterior pull handles, suitable for use while wearing
firefighter gloves. The handles shall be made of a fiber reinforced plastic composite with a black matt
finish.
The interior exit door handles shall be flush paddle type with a black finish, which are incorporated into
the upper door panel.
REARVIEW MIRRORS
West Coast style single vision mirror heads shall be provided and installed on each of the front cab doors.
The mirrors shall be mounted via 1.00 inch diameter tubular stainless steel arms to provide a rigid
mounting to reduce mirror vibration.