Specifications

AS BUILT WIRING DIAGRAMS

The cab and chassis shall include one (1) digital copy of wiring schematics and option wiring diagrams.

FLUID DATA LABEL

A permanent data label shall be affixed in the driver's compartment specifying quantity and type of the

following fluids used in the vehicle.

1. Engine Oil

2. Engine Coolant

3. Chassis Transmission Fluid

4. Pump Transmission Lubrication Fluid

5. Pump Primer Fluid

6. Drive Axle Lubrication Fluid

7. Air Conditioning Refrigerant

8. Air Conditioning lubrication oil

9. Power Steering Fluid

10. Cab Tilt Mechanism Fluid

11. Transfer Case Fluid

12. Air Compressor System Lubricant

13. Generator System Lubricant

14. Front Tire Cold Pressure

15. Rear Tire Cold Pressure

16. Equipment Rack Fluid

OVERALL HEIGHT/WIDTH/LENGTH/WEIGHT DATA PLATE

There shall be a high-visibility placard located in direct view of the seated Driver, which shall indicate, in

feet-and-inches; the overall height of the vehicle (to the highest permanent point-except antennas), the

overall width (at steps, fenders, and rub rails-not retractable mirrors), and overall length of vehicle

(bumper to tailboard). The data plate shall also indicate, in pounds, the vehicle's total "as delivered"

weight.

BUMPER EXTENSION GRAVELSHIELD, POLISHED ALUMINUM TREADPLATE

The area between the specified extended front bumper and the front of the chassis cab shall be provided

with a flat panel gravel shield, fabricated of polished 4-way aluminum treadplate with NFPA approved

slip resistant pattern. The gravel shield shall custom fit the profile of the curved wrap-around bumper,

outboard radius cab corners, and the cab/grille with accommodations for cab hinge points. Driver and

passenger outboard sides of the gravel shield shall be equipped with "boxed" vertical end panels,

extending from tails of bumper, wrapping inboard to the cab sides. Underside of gravel shield shall be

properly reinforced to accommodate the specified gravel shield mounted optional accessories.

BUMPER EXTRICATION TOOL & HOSE REEL COMPARTMENT

Front bumper shall be equipped with full width fully enclosed rescue tool and reel compartment, designed

to accommodate: interior outboard mounting of two (2) round disc hydraulic hose reels and two (2) pre-

connected rescue tools beneath a closed full width lid/cover (reels and/or rescue tools to be optionally

specified as follows).