Specifications

38
indicate the functionality of the sensor and battery. If the sensor and battery are in working condition, the
LED shall immediately start blinking.
TIRE VALVE CORE EXTENSIONS
Two (2) each "rigid" metal valve core threaded extensions shall be provided, installed on the inside dual
rear tires of the vehicle's rear axle. Inside dual wheels shall be positioned so that the valve core
extensions protrude through the outside dual wheels, located directly across from the outside dual wheel's
valve core.
MUDFLAPS
Driver's side and passenger's side rear body wheel well mud flaps shall be furnished made of fabric
reinforced neoprene rubber, bolted to the rear wheel well bulkheads using stainless steel strap brackets
and bolts. Mud flaps shall extend approximately 10" below running board level.
CAB CEILING MAP LIGHTS
Two (2), each 12-volt interior rear cab ceiling mounted map/dome lights to be furnished, located
overhead the outboard forward facing rear seated positions. Lights to be equipped with fixture mounted
switches and CLEAR lens. Lights shall also be activated by opening of either one of the rear cab doors.
MASTER BATTERY SWITCH
A two-position battery "cut-off" switch, with green "battery-on" pilot light shall be furnished, as specified
in CHASSIS SECTION, mounted to be easily accessible and visible to seated driver, and from exterior
ground level (through open driver's door).
2-CHASSIS CAB INTERIOR - 125-VOLT POWER STRIPS, SHOREPOWER
Two (2), 125-volt, household 15-amp 3-wire 4-place plug-in power strips, with 5-15 receptacles shall be
furnished, interior of chassis cab, each strip located as designated, equipped with protected line voltage
wiring to the specified shoreline, and engraved nameplates identifying voltage and power source.
The above specified "chassis cab" line voltage power strips shall be located in the EMS cabinet in the rear
of the crew cab.
CREW CAB INTERIOR - 125-VOLT 5-20R RECEPTACLE, SHOREPOWER
One (1), 125-volt, household 20-amp 3-wire duplex (2-total) plug-in receptacle shall be furnished, interior
of crew cab, located as designated, with: surface mounted cast aluminum receptacle box, 125-volt 3-wire
5-20R household plug-in receptacle, metal cover plate, protected wiring to the specified shoreline, and
engraved nameplate identifying voltage and power source.
The above specified "Crew Cab" line voltage receptacle shall be located on the exterior wall behind the
driver’s seat above the maintainer.
RADIO ANTENNA MOUNT
One (1) antenna mounting base, Model MATM, with at least 17 feet of coax cable and weatherproof cap
are to be provided, for use with Customer's radio installation. Mount to be located on exterior cab roof,
coax cable to be routed to the interior driver's compartment.