Specifications

39
10-PLACE "HOT" CIRCUIT PANEL: CUSTOMER'S RADIOS/COMPUTERS/PHONES
A continuously "HOT" breaker panel, with 10 each 12-volt power positions and individual vehicle
grounds shall be provided, inside the chassis cab, for use with Customer's installed radios, cell phones,
computers, and other 12-volt powered accessories.
10-PLACE IGNITION POWERED CIRCUIT PANEL: CUSTOMER'S ACCESORIES
A vehicle Ignition Switch-ON powered breaker panel, with 10 each 12-volt power positions and
individual vehicle grounds shall be provided, inside the chassis cab, for use with Customer's installed 12-
volt powered accessories
SIGTRONICS INTERCOM SYSTEM
A Sigtronics model US-67D intercom system to be furnished and installed, capable of interfacing with
two (2) 2-way radio systems as furnished by the Customer. Installation to include: Dual Radio Intercom
Station, six (6) SE-8 Headsets with behind-the-head dual ear coiled cord, Flex Boom with ultra foam
wind screen, and Mobile Radio Adapter.
Intercom installation to include: wiring and mounting of all intercom plug-in receptacles, mounting of
headset hanger brackets (at each seated position), and appropriate interfacing for the Customer's mobile 2-
way radios. Locations of components shall be determined at Pre-Build.
CHASSIS CAB REARWARD EXTENSION/AUGMENTATION
The specified medium 4-door "custom" chassis cab shall be modified as follows:
The upper back wall of the chassis cab shall be extended rearward to allow for recessed mounting of the
specified interior rear cab forward facing crew seats. The rearward cab extension design is to be in
keeping with the original equipment manufacturers (OEM's) cab roof top profile, including matching
horizontal outboard roof cap radius extrusions. All rearward cab extension fabrications shall be of the
same type of aluminum, but of heavier material thickness than the OEM materials.
Aluminum construction materials and shall include: .187" horizontal roof plate and vertical rear and side
panels. The seats mounting platform, shall be of .375" total thickness. Rectangular heavy wall aluminum
extrusions shall be provided, vertically and horizontally, creating a superstructure grid work, horizontally
underside the roof panel and vertically inboard the rear panel. In addition to the above construction
materials, the exterior rear wall, full height and full width, shall be overlaid with polished 4-way
aluminum treadplate for a scuff resistant surface.
The extended area shall have an overall length of 21" (front-to-rear), width of 38" wide (side-to-side), and
minimum height of 50". The rearward extension's roof top is to be "flush" with forward chassis cab roof
top. Overall width of the cab extension/augmentation is to be commensurate with the apparatus
compartment module located immediately to the rear and below the extension.
Bottom/floor of the rearward cab extension shall be approximately 16" above the interior chassis cab
floor, at least 22" above the chassis frame rails, providing a mounting platform which is cantilevered over
the optionally specified compartmentation and/or multiple "waist-high" pre-connect hose beds.
The cab extension shall be for the storage of medical equipment and will include three (3) adjustable
shelves and a roll up door with integrated LED strip lights.