Specifications

40
NOTE: Color photos of the proposed cab rearward augmentation, and its features, shall be provided to
the purchaser.
HELMET HOLDERS
The six (6) driver and passenger seats in the chassis and/or crew cabs shall each be assigned, and
interior(s) equipped with a Ziamatic, model UHH-1 helmet holder. Helmet holders shall be supplied by
the manufacturer.
STREAMLIGHT LITEBOX LANTERN/FLASHLIGHT
Four (4) each, Streamlight model 45815, orange dual filament lantern(s)/flashlight(s) shall be furnished,
complete with charge rack and charger cord for 12-VDC. Light(s) to have an 8-watt spot bi-pin bulb for
"back-up" beam. Light charger(s) to be installed inside the chassis cab and wired to the vehicle's 12-volt
electrical system "hot" at all times. Location to be determined at pre-build conference.
STREAMLIGHT SURVIVOR FLASHLIGHT(S)
Six (6) each, Streamlight model 90509 orange, “Survivor" flashlight(s) shall be furnished, complete with
12v DC charger. Light charger(s) to be installed inside the chassis cab and wired to the vehicle's 12-volt
electrical system "hot" at all times. Location to be determined at pre-build conference.
NEDERMAN TRANSMITTER
One (1) Nederman exhaust system fan auto start transmitter model number 87000318 shall be furnished
and installed on the apparatus. It shall be located on the front of the dashboard next to the windshield to
allow the activation of the Fargo Fire Departments exhaust system when the apparatus starts up and when
the apparatus gets close to the station and backs in.
GPS TRANSMITTER
One (1) GlobalSat GPS transmitting puck model number MR-350P shall be furnished and installed on the
apparatus. The GPS puck shall be mounted on the roof of the apparatus in front of the light bar on the
passengers’ side of the apparatus. The wire for the puck shall be run under the headliner and down the
post to the location of the computer mount. When mounting the puck the manufacturer shall seal up the
hole with silicone so water does not enter the cab.
MANUAL, BODY PARTS ONLY
One (1) custom parts manual(s) for the factory installed parts only shall be provided in hard copy with the
completed unit.
The manual shall contain the following:
- Job number
- Part numbers with full descriptions
- Table of contents
- Parts section sorted in functional groups reflecting a major system, component, or assembly
- Parts section sorted in alphabetical order
- Instructions on how to locate parts