Specifications

REAR BODY FACE CONSTRUCTION MATERIAL

Exterior rear face of body, including: passenger's side rear door jamb, driver's side rear door jamb, and

rear top header (below hosebed) shall be fabricated of type 304 smooth plate stainless steel, to allow for

application of reflective graphics.

COFFIN STYLE STORAGE PODS, LIFT-UP HATCH STYLE LID

One (1) each, modular coffin style storage pod(s) to be furnished, of maximum width, length, and depth,

as is allowed by the cavity provided between the specified overhead longitudinal squad panels and

extended body corners.

Storage pod(s) to be designed to slip down into the top cavity opening, leaving a void space between pod

and squad panels, thus providing a "double-wall" protection of the squad panels. Each modular pods is to

have a double-broke-flange top perimeter which mates to and interlocks with the cavity top perimeter

flanges. Storage pod(s) to be bolted to and easily removable from the cavity flanges. Bottom of storage

pod(s) to be provided with a drain port and clear nylon tubing extending to beneath the apparatus body.

Each storage pod is to be provided with a single piece lift-up hatch style lid (cover), with: surrounding

perimeter flange, "concealed" full lid length outboard stainless steel piano hinge bolted to pod and lid,

single top centerline exterior stainless steel large diameter 1/4-turn D-ring door latch handle with

underside rubber gasket, two-point sliding rod latches, door jamb mounted plunger switch to activate the

optionally specified interior 12-volt lighting, two (2) pneumatic lift assists/stay-open props, and

replaceable full perimeter rubber weather-stripping.

The storage pod(s) are to be fabricated smooth aluminum with a "swirl" machined natural aluminum

finish. The hatch lid (cover) is to be fabricated of .187" polished 4-way aluminum tread plate.

RECESSED LIGHT TOWER STOWAGE CAVITY

One (1) transverse recessed well/cavity area shall be furnished in the upper level front portion of the

apparatus body, ahead of the specified transverse cavity storage pod. Well/cavity area to be at least 68"

wide (front-to-rear) x 78" wide (side-to-side) x 20" deep, designed to accommodate a fully recessed

folding/extendible Light Tower. Well/cavity area to be fabricated entirely of polished 4-way aluminum

tread plate material, underside barrier coated, perimeter seal caulked, and equipped with bottom floor

drains with PVC hoses extending down through the squad side walls and underside compartments, to the

underbody area. The floor of light tower cavity shall be reinforced, providing a rigid structure for support

of lift-up/extending light tower.

TRANSVERSE FORWARD STORAGE POD

One (1) modular cavity pod shall be furnished, of maximum size, designed to slip down into the cavity

opening ahead of the specified longitudinal walkway, rear of the specified light tower cavity. The

modular pod shall have a double break fabricated perimeter which interlocks with the squad side panels,

body front panel, and walkway front panel top flanges.

A single custom fit pod cover shall be furnished, materials and design as specified above. The underside

of storage pod cover shall be provided with two (2) 5" diameter 12-volt surface mounted light fixtures,

activated with a door jamb mounted plunger switch.