Specifications

61
ALUMINUM PLATE ADJUSTABLE HEIGHT PULL-OUT TRAY(S)
Three (3), each fabricated .190" natural unpainted sanded finish aluminum pull-out pan style tray(s) shall
be furnished. Pan tray(s) shall be of maximum width for door opening, and maximum front-to-rear
dimension for the designated compartment. Tray(s) are to be provided with 2-1/2" deep perimeter
flanges, seam welded at all four corners, and bolted to underside roller mechanism. Each pan tray shall
mount to a 500 lb. capacity SlideMaster or equivalent single direction, multi-section, powder-coat
painted, 70% extension roller slide assembly.
The pan style tray's underside roller mechanism shall be bolted to and removable from a vertically
adjustable slide assembly, allowing infinite adjustment up and down of the roll-out tray within the
specified compartment. Vertical slide assembly shall have same 500 lb. rating as the roller assembly.
Customer shall designate the tray's initial height above the interior compartment floor level.
Location to be determined at pre-build conference.
ALUMINUM PLATE PULL-OUT TRAY(S)
two (2), each fabricated .190" natural unpainted DA sanded finish aluminum pull-out pan style tray(s)
shall be furnished. Pan tray(s) shall be of maximum width for door opening, and maximum front-to-rear
dimension for the designated compartment. Tray(s) are to be provided with 2-1/2" deep perimeter
flanges, seam welded at all four corners, and bolted to underside roller mechanism. Each pan tray shall
mount to a 600 lb. capacity SlideMaster model SM3 or equivalent single direction, multi-section, powder-
coat painted, 100% extension roller slide assembly
.
Location to be determined at pr- build conference.
ALUMINUM ROLL-OUT/TIP-DOWN TRAY(S)
Four (4), each fabricated smooth natural machine "swirl" finish .190" aluminum roll-out-tip-down pan
style tray(s) shall be furnished, located above floor level of specified compartment(s). Roll-out-tip-down
Pan tray(s) shall be of maximum width for door opening, and maximum front-to-rear dimension for the
designated compartment, with 2-1/2" deep perimeter flanges, bolted to underside 250 lb. capacity
SlideMaster SMT or equivalent single direction, "roll-out-and-down", roller slide assemblies
. Roller slide
assembly is to be provided with side mounted brackets which allow infinite vertical adjustment using
standard adjustable shelf tracks.
Location to be determined at pre-build conference.
PULL-OUT TOOL BOARDS
Five (5) each, vertical pull-out .250" aluminum flat panel tool board panels to be furnished. Panels to be
at least 60" high x 24" deep (front-to-rear), equipped with top and bottom (2-each) mounted Grant
cadmium plated roller slides, spring-loaded retract lock, and full height outboard double broke hand-grasp
flange.
Location to be determined at pre-build conference.