Specifications

LIGHTING INSTALLATION REQUIREMENTS

All specified light fixtures to be located/fitted prior to and re-installed after finish painting. Where fixture

wiring passes through metal body panel, the pass-thru hole to be equipped with a rubber grommet. All

specified light fixtures shall be installed, using stainless steel screws with non-metallic "replaceable"

threaded inserts, to allow removal of light fixture, from exterior of body. Where light fixtures are to be

installed on a painted panel, all light fixture mounting holes, grommet holes, and fastener holes shall be

machined/cut-out prior to prime and finish painting, so that all metal edge surfaces receive the same

protective coating. Where holes are cut or drilled, after finish painting, same holes shall receive paint

finishes prior to insertion of fasteners and threaded inserts.

REAR STEP LIGHTS, SHIELDED

Two (2), 2" round chrome plated surface mount 12-volt "shielded" step lights to be furnished, located to

illuminate tailboard step surface at the rear of the body. Lens to be 1-1/2" diameter, clear. Lights to be

activated by parking brake set.

REAR MARKER

Five (5), rectangular surface mount multiple element LED marker lights with reflective red lenses are to

be furnished, located: two (2) recessed into specified rear tailboard corners and three (3) recessed behind

center rear tailboard flange diamond shape cut outs. Marker lights to be activated by headlamp switch.

The three (3) marker lights located at the rear to be:

As close as is practical to the vertical Centerline.

Centers spaced not less than six (6) inches or more than twelve (12) inches apart.

All at the same height.

The two (2) outside marker lights located at the rear shall be installed:

To indicate the overall width of the vehicle.

At the same height.

To be visible from both the rear and the side.

MID-TURN/MARKERS

Two (2), round or rectangular surface mount mid-ship dual element, combination marker & turn lights,

are to be furnished, located: one (1) driver's side mid-ship vehicle and one (1) passenger's side midship

vehicle. Light fixtures are to have Amber lens. Marker Light is to be steady on with headlights, Turn

Lights are to have flashing element, activated by vehicle turn signals.

The two (2) outside Marker/Turn lights are to be visible in rear view mirrors.

STOP/TAIL LIGHTS

Two (2), Whelen model 6OROOBRR, Red element 5" x 8" rectangular surface mount LED combination

stop/tail lights to be furnished, mounted each side at rear of body. Lights to be wired for activation by

service brake and headlamp switch.