Specifications

71
COMPARTMENT INTERIOR FINISH
The interior compartments shall remain the natural #4 "brushed" stainless steel finish, as previously
specified. All natural finish surfaces shall remain protective vinyl covered throughout the manufacturing
process.
DISSIMILAR METALS
During assembly all 4-way aluminum tread plate components, shall be seal coated where mated to non-
aluminum components. 4-way aluminum fabrications to be installed using stainless steel button socket
head cap screw fasteners. Edges of 4-way aluminum, where meeting exterior body painted fabrications,
shall be properly caulked with G.E. or equal silver metallic body sealant to prevent moisture
accumulation between metal layers.
TOUCH-UP PAINT
One (1), full quart of original finish color top coat paint material shall be provided for use as future touch-
up paint.
TECTYL NON-HARDENING UNDERCOATING
After final body reassembly, under body areas shall be spray coated with Tectyl or equal rust proofing
undercoating material. Vehicle exterior painted surfaces shall be PrepSol "solvent washed" after
undercoating, to remove all overspray residues.
REFLECTIVE STRIPING
Three (3) reflective stripes shall be provided across the front of the vehicle and along the sides of the
body. The reflective band shall consist of a 1" white stripe at the top with a 1" gap then a 4" white stripe
with a 1" gap and a 1" white stripe on the bottom. Where Chevrons are not specified, a matching color 4"
band shall be provided at the rear of the apparatus.
The reflective band provided on the cab face shall be below the front grille on the front bumper.
"Z" JOG IN REFLECTIVE STRIPE
There shall be a "Z-shaped" jog in the reflective stripe design. Jog shall be located in the mid-section of
the apparatus body, uninterrupted by wheel well cut-out and/or pump control panel.
GOLD LETTERING, BLACK SHADED
Driver's side and passenger's side chassis cab front doors shall be furnished with CAD generated machine
cut simulated Gold Leaf lettering, suitably shaded with Black vinyl.
Forty-one (41) to sixty (60) CAD generated machine cut simulated gold leaf letters, 3.00" tall, highlighted
with black vinyl shading shall be provided.
Lettering to be encapsulated between two (2) layers of Mylar, for protection and longevity.