Specifications

73
A power source specification label shall be permanently attached to the apparatus near the operator’s
panel. The label shall provide the operator with the following information: rated voltage and type
(AC/DC), phase, rated frequency, rated amperage, continuous rated watts, power source and engine
speed.
HARRISON INTEGRATED HYDRAULIC TECHNOLOGY
A Harrison Integrated Hydraulic Technology system is to be provided for use with the specified Harrison
Generator as well as the specified accessory hydraulic system.
The system shall incorporate a transmission mounted power take off coupled with an axial piston pump
capable of supplying all required flows and pressures required for the system. Gear pumps shall not be
allowed.
The system shall incorporate a dynamic custom designed hydraulic manifold that will route the fluid
under pressure to the required component systems as selected by the apparatus operator.
The system shall include integrated electronic switch controls located as needed and determined by the
purchaser.
The system shall be fully operable with the vehicle in motion (forward and reverse) or at a stop with
parking brake applied.
There shall be a "Master Hydraulic" power switch located on the cab dash switch panel at the driver's
position. When activated, this switch will engage the transmission mounted PTO for the hydraulic pump,
the hydraulic fluid heat exchanger fan, and indicate "Hydraulic Power Ready" for the available
components.
Control switches for activating hydraulic power to the other vehicle components shall be located in a
common switch panel immediately next to or inclusive with the Master Hydraulic switch panel. Remote
switch locations for the other vehicle components can be located elsewhere on the apparatus as needed.
By using the switches, the operator can direct the integrated hydraulic system to power or shut off the
required components as needed.
All hydraulic filters utilized shall be fully accessible and removable from the top of the reservoir, no
exceptions.
The drain line for the hydraulic fluid reservoir shall be fitted with a stainless steel ball valve, sealed in the
closed position with a cable tie to prevent accidental opening. Drain lines shall be routed to the bottom of
the apparatus for easy removal of hydraulic oil. The drain lines shall be fitted with a sealing plug to keep
out contaminants and road debris.
GENERATOR LOCATION, OVERHEAD BODY IN RECESSED DUNNAGE
The above specified hydraulic generator shall be mounted within an open dunnage area located above the
driver side forward full height compartment, outboard of the water tank, with allowances made for proper
venting.
Floor drain is to be provided, with drain hose extending to below the apparatus body.
GENERATOR CIRCUIT BREAKER PANEL
One (1), Square-D 100-amp, 32 place circuit breaker panel with appropriately sized main breaker and
individual switch type manual-reset load suitable circuit breakers to be furnished, for single phase
generators up to 25,000 watts. Panel to be located inside a weatherproof apparatus body compartment
(Customer approved location), provided with waterproof non-metallic flexible conduit (extending from
generator to circuit breaker panel and circuit panel to electrical accessories), with appropriate size multi-