Owner’s Manual

ADJUSTING THE OPEN SIGHTS (Selected Models ONLY)

Some models come from the factory equipped with ﬁ ber-optic open sights. To

adjust the sights to the bullet’s point of impact you should ﬁ re at least 2 shots

at the target before making adjustments. Adjust your sights to the center of the

group. The “rule of thumb” to remember is that you move the rear sight the same

direction that your bullet hit must move. In other words, if you need your group to

go to the right, move the rear sight to the right. If you need your group to go up,

move the rear sight up. Loosen the screw on the sight to allow for movement and

retighten securely afterwards.

SCOPE MOUNTING

CVA ﬁ rearms come drilled and tapped for easy installation of a scope and mounts.

Do not drill additional holes in your barrel as this can weaken the barrel and cause

it to burst, resulting in severe injury or death.

CVA uses and recommends the DuraSight™ brand of precision scope mounts

and rings to compliment your CVA ﬁ rearm. These quality mounts and rings

should be available from the dealer where you bought your gun. If not, contact

CVA Customer Service. Follow the scope mount manufacturer’s recommended

instructions when installing the mounts and rings. The use of Loctite™ 242 thread-

locking compound or equivalent is recommended. Take care to assure that the

front bell on the scope is not contacting the barrel. Make sure that the rear bell

of the scope is an appropriate distance from your eye so that you are not struck

by the scope during recoil.

SERVICE & REPAIR

Should your CVA ﬁ rearm require repair, we recommend that it be returned to our

Warranty Repair Center. This will assure that our competent staff of trained

technicians performs all work. Under U.S. law, your ﬁ rearm can be shipped by

you directly to our warranty repair center, and we can return it directly to you at

the address it was originally shipped from If you use a dealer or gunsmith to

ship the firearm, we must return it to the same dealer or gunsmith. NO

EXCEPTIONS WILL BE MADE. (Section 178.147 Federal Firearms Regula-

tions). Contact CVA Customer Service for a Return Authorization prior to ship-

ping your gun. Any ﬁ rearm returned to the repair center should be marked to the

attention of BPF REPAIR DEPARTMENT. Please return the entire gun even if

you feel the problem is with the barrel. A detailed letter of instructions should be

enclosed to facilitate handling. Please be sure to include your name, shipping

address, and a daytime phone number. All ﬁ rearms must be unloaded and

shipped via United Parcel Service (UPS) or U.S. Postal Service. Shipping

a loaded gun is not only dangerous and irresponsible; it is a violation of the law

that must be reported.Once received, our Repair Center will inspect and evaluate

the problem. Should any work not be covered by warranty, you will be advised of

the cost. No unwarranted work will be done without your approval. The address

for the CVA Repair Center is:

BP FIREARMS COMPANY, LLC

ATTN: REPAIR BPF DEPARTMENT

1270 PROGRESS CENTER AVE. • SUITE 100

LAWRENCEVILLE, GA 30043