Elevator surveillance with Wlan solution/ User guide 1. Parts List Receiver Group 2.4G Receiver Antenna DC12V Adaptor and RX IP Extender 2.
Elevator surveillance with Wlan solution/ User guide Transmitted Group 2.4G Antenna DC12V Adaptor and TX IP Extender No. 1 2 Parts number F-CS-WIFIRX-001 F-CS-WIFIRX-002 3 F-CS-WIFIRX-003 4 5 F-CS-WIFITX-001 F-CS-WIFITX-002 6 F-CS-WIFITX-003 7 NVR019 8 F-CS-I13-D09-40-B4-1 9 Adapter014 2.4G antenna Cable(30CM) IP Camera Parts name/ Specification. 2.4G Receiver IP extender 2.4G Receiver Antenna/ 12dbi 2.4G Antenna Cable(3m)/ RP-SMA Male to N Type Male 2.4G transmitted IP extender 2.
Elevator surveillance with Wlan solution/ User guide Transmitted Group 2. Installation guide Wlan Infrastructure-1 in Elevators.
Elevator surveillance with Wlan solution/ User guide Wlan installation structure in Elevators. Install the Cat. 5e/ Cat.6 network Cables and DC 12V Power supply and connected the IP camera in the elevator car; the antenna and TX IP extender are outside of the elevator car. Install the DC 12V Power supply and connected the antenna and RX IP extender in the bottom or top of the elevator tunnel. Wired and install the Cat. 5e/ Cat.6 network Cables from the RX IP Extender to the control room.
Elevator surveillance with Wlan solution/ User guide 3. The Procedure: 1. The IP camera installs inside of the elevator car and connect the DC power supply with the elevator car. 2. And install the TX IP Extender and the transmitting antenna are on the bottom of the elevator car; and install other DC power supply to the TX IP Extender. Then, Use the 30cm antenna cable connect the antenna and IP Extender. 3. Install and Connect the Cat.5e/ 6 cable with IP Camera and TX IP Extender. 4.
Elevator surveillance with Wlan solution/ User guide RJ45 DC 12V CAT.5e/ 6 Antenna Cable ` The each waterproof connector needs to be locked, the power supply, antenna, and network RJ45 on the RX/ TX IP Extender.
Elevator surveillance with Wlan solution/ User guide Example Wlan Installation Photo (The Building height under the 45 floors) Receiver Receiver use 3m ANTENNA Transmitter TX Transmitter use 30 cm
Elevator surveillance with Wlan solution/ User guide Wlan Installation Photo (The Building higher than the 45 floors) Receiver parts Receiver use 3m ANTENNA Transmitter Transmitter use 30 cm parts
Elevator surveillance with Wlan solution/ User guide The Receiver IP extender The AC Power supply Antenna Cable The DC 12V adaptor Cat.
Elevator surveillance with Wlan solution/ User guide 1. The receiver IP Extender box and receiving antenna are placed at the bottom of the elevator tunnel. The actual installation position is depends on the site environment. 2. The antenna devices must not interfere with the original wire of the elevator. 3. The transmitting antenna should be aligned with the receiving antenna, and should not deviate too far. 4. RJ45 network cable connector. This device complies with part 15 of the FCC Rules.
FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device must not cause harmful interference, and 2. This device must be able to withstand any interference received, including interference that may cause undesired operation. FCC Warning This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.