Installation Instructions

Contractors Wardrobe
®
, 26121 Avenue Hall, Valencia, CA 91355 | Phone: [phone] Fax: [phone] | CwDoors.com
Model 750-PRIN-1280-0220
7
B. Gently lower the Rollers into position so that
they are seated in the track. Make sure that the
Panel rolls freely.
C. Hold the Outside Door Panel so that the Rollers
are facing towards you. Standing outside of and
facing the shower enclosure, use the index finger
of both hands to carefully push the Inside Door
Panel back and out of the way as you lift the
Outside Door Panel up and over the Curb and then
slide the Top Rail up and into the Header (See Figure
9). Or, if someone is assisting you, have him/her
hold the Inside Door Panel back out of your way.
DO NOT let the two Panels strike one another. Set
the Rollers into the front track of the Header.
D. VERY CAREFULLY seat the Outside Door Panel
into the track and make sure that it rolls freely.
Carefully let the Inside Door Panel ease back into
position.
E. Slide both Panels to one side.
Outside
Shower
D
Push
Inside
Panel
away with
your
fingers
C
Step 10 Installing the Guide
A. Locate the Guide and one #6 x 3/8” PH SMS
Screw. Standing inside the shower, position the
Guide on the Curb exactly midway between the
Wall Jambs. The Guide will lay flush on the Curb.
B. Using the hole in the Guide, drill a 1/8” hole
into the Curb.
C. Use a #6 x 3/8” PH SMS Screw to secure the
Guide in place (See Figure 10).
Install the
Guide midway between the
Wall Jambs
Figure 9
Step 11 Installing the Towel Bar
A. Locate the Towel Bar, two Towel Bar Brackets,
two #6 x 1/4” “B”-Point Screws, and two #8 x 1/2”
PH B PT Screws. Refer to the IPB Drawing to help
identify these parts.
B. Align the pre-drilled hole in the Towel Bar
Bracket with the pre-drilled hole in the door Side
Rail of the Outside Door Panel. Use a #6 x 1/4”
“B”-Point Screw to loosely attach the Towel Bar
Bracket to the door Side Rail of the Outside Door
Panel. Repeat these same steps for the other side.
C. Align the pre-drilled hole in the Towel Bar with
the pre-drilled hole in the Towel Bar Bracket . On
the Outside Door Panel use a #8 x 1/2” PH B
PT Screw to secure the Towel Bar to the Towel Bar
Bracket. Repeat these same steps for the other
side.
D. Tighten the two #6 x 1/4” “B”-Point Screws to
the Side Rail of the Outside Door Panel.
Figure 10