DX400E-DE / DX600E-DE / DX800E-DE User’s Manual K01-0000114-00
IMPORTANT SAFETY INSTRUCTIONS This manual contains important instructions that should be followed during installation and maintenance of the UPS and batteries. Please read and follow all instructions carefully during installation and operation of the unit. Read this manual thoroughly before attempting to unpack, install, or operate. CAUTION! The UPS must be connected to a grounded AC power outlet with fuse or circuit breaker protection. DO NOT plug the UPS into an outlet that is not grounded.
BASIC OPERATION DESCRIPTION ① Power On/Off Switch Press the power switch to turn the UPS ON or OFF. LED Indicators ② Three LED indicators include Using AC, Using Battery, and Fault. Refer to “Definitions for Illuminated LED Indicators” section for details. ③ Battery Capacity Indicators The indicators show the battery capacity remains during battery mode. Refer to “Definitions for Illuminated LED Indicators” section for details.
Hardware Installation Guide 1. 2. 3. 4. 5. 6. 7. 8. 9. Your new UPS may be used immediately upon receipt. However, recharging the battery for at least 8 hours is recommended to ensure that the battery's maximum charge capacity is achieved. Charge loss may occur during shipping and storage. To recharge the battery, simply leave the unit plugged into an AC outlet. The unit will charge in both the on and off position. If you will use the software, connect the USB cable to the USB port on the UPS.
DEFINITIONS FOR ILLUMINATED LED INDICATORS Icon Name Using AC Alarm Condition OFF Normal Beep twice every 30 seconds Utility Failure – The UPS is providing power to battery power-supplied outlets from its battery. Rapid beeping every 1/2 second Utility Failure – The UPS is providing battery power. Rapid beeping indicates the unit will run out of power shortly. Constant Tone Battery Overload – Occurs when connected equipment exceeds the listed capacity of the UPS.
TECHNICAL SPECIFICATIONS Model Capacity (VA) Capacity (Watts) Input Input Voltage Range Frequency Range Output On Battery Output Voltage On Battery Output Frequency Transfer Time Overload Protection Surge Protection Lightning / Surge Protection Physical Total # of UPS outlets Maximum Dimensions(LxWxH) Weight (kg) Battery Sealed Maintenance Free Lead Acid Battery Typical Recharge Time Status Indicators Indicators Audible Alarms Environment Operating Temperature Relative Humidity Communication ® PowerPanel Pe
TROUBLESHOOTING Problem Full-time surge protection outlets stop providing power to equipment. Circuit breaker button is projecting from the side of the unit. The UPS does not perform expected runtime. The UPS will not turn on. Possible Cause Circuit breaker has tripped due to an overload. Battery not fully charged. Battery is slightly worn out. The on/off switch is designed to prevent damage by rapidly turning it off and on. Solution Turn the UPS off and unplug at least one piece of equipment.
