User's Manual

Page 2-12 Ch 2
I
I
I
I
.
.
U
U
s
s
i
i
n
n
g
g
y
y
o
o
u
u
r
r
P
P
C
C
-
-
E
E
P
P
h
h
o
o
n
n
e
e
f
f
o
o
r
r
t
t
h
h
e
e
f
f
i
i
r
r
s
s
t
t
t
t
i
i
m
m
e
e
Follow the steps below to start using your PC-EPhone for the first time.
(1) Installing the Battery to PC-EPhone
Install the main battery to your PC-EPhone as shown below.
The Main Battery may be drained during the transportation from the factory to the
consumer; therefore you had better connect the external power to the cradle and place
your PC-EPhone in it in order to charge the battery when using your PC-EPhone for
the first time.
(2) Check the following operations of your PC-EPhone
After connecting your PC-EPhone to a power source and pressing the Power button,
the CYBERBANK logo will be displayed for approximately 2 seconds, and then gives
way to a display that will help you calibrate the touch screen.
A target (+) will move in the order of “center
→ upper left → lower left → lower
right
→ upper right”, to different locations on your screen. Since calibrating the
touch screen has a direct affect on the recognition ability of your touch screen, be sure
to accurately tap the center of the target (+) with your stylus. For more information,
see the Setting PC -EPhone Preferences section in Chapter 3 .
(3) Setting System Preferences
Before using your PC-EPhone, you should customize it to your needs by setting basic
system preferences in the
Control Panel . You may also set preferences during use. On the
Start menu, tap Settings , and then point to Control Panel and set system configurations.
For more information, see the Setting PC -EPhone section in Chapter 3 .
Move the Battery Lock downward and place the battery in the slot leaving 4 ~
5 mm space and push it firmly, and be careful not to get the battery caught in
the groove of PC-EPhone’ s battery slot. While inserting the battery, the
battery slot can be damaged if excessive force is used. And then move the
Battery Lock upward.
leaving 4~5mm space and push