Product specifications

Installing the VoIP V2 Paging Amplifier
Paging Amplifier Setup
Operations Guide 930363G CyberData Corporation
9
High Power Mode
Figure 2-5. Using the Amplified Outputs—High Power Mode
Cat 5 Ethernet Cable
802.3at PoE Injector (high power mode)
2 speakers in parallel (4 Ohm total)
+
Note: Use wire nuts to connect wire
from the speakers to 16 gauge wire.
Note: You can use an 802.3at
compliance switch instead of an
802.3at power injector and hub.
Twist wire nuts
Optional 2 Speaker Configuration
(802.3at mode)
8 Ohms
Standard 1 Speaker Configuration
(802.3af mode)
8 Ohms
16 gauge wire
25 feet maximum distance
Use 16 gauge wire coming out of screw terminals.
Note: Make sure that the wire length going to the
wire nuts is kept short (approximately 6 inches).
+
+
*
*Note : The positive (+) wire coming from the speaker
may be red or white. The negative (-) wire is black.
Non-PoE Ethernet Switch