Product specifications

Operations Guide 930098F CyberData Corporation

2.3 Setting up the VoIP Paging Gateway

Before you set up the VoIP Paging Gateway, be sure that you have received all the parts described in

Section 2.1, "Parts List".

To set up the VoIP Paging Gateway, see the following sections:

• Section 2.3.1, "Connect to the Power Source"

• Section 2.3.2, "Connect to the Network"

• Section 2.3.3, "Confirm that the VoIP Paging Gateway is Working Properly"

• Section 2.3.3.1, "Confirm Power on, Network Connectivity, and Connection Speed"

• Section 2.3.3.2, "Verify Network Activity"

• Section 2.3.4, "Connect to a Paging Device"

• Section 2.3.4.1, "Connect the VoIP Paging Gateway to a Paging Amplifier"

• Section 2.3.4.2, "Connect the VoIP Paging Gateway to a Telephone"

• Section 2.3.5, "Broadcast a test message to all paging zones"

• Section 2.3.6, "Restore the Factory Default Settings as Required"

2.3.1 Connect to the Power Source

To use PoE, plug a Cat 5 Ethernet cable from the VoIP Paging Gateway Ethernet port to your

network. As an alternative to PoE, you can plug one end of a +48V DC power supply into the Paging

Gateway, and plug the other end into a receptacle. Connect the earth grounding wire to the chassis

ground on the back of the unit.

Figure 2-2. Connecting to the Power Source

48V DC

Chassis

ground