USER MANUAL DVR 1600

CONNECTING THE DVD RECORDER

3 Plug the SCART cable into the SCART socket “EXT1 TO TV”

(SCART-1) at the back of the DVD recorder and into the corresponding

SCART socket of your TV (please refer to the user‘s manual of your

TV).

4 Turn on the TV.

5 Connect the supplied AC power cord to the “AC IN” socket on the

back side of the DVD recorder, then plug into a power outlet.

6 Turn the unit on with the “POWER” button on your remote control or

the “STANDBY/ON” button on the front panel of the DVD recorder.

“HELLO” appears in the display.

7 If the connection was properly made and your TV was automatically

switched to the programme number for the SCART socket, e.g. “EXT”,

“0”, “AV”, the picture shown on the left side appears.

Then, read section “Initial installation” in chapter “Installing your DVD

recorder” (see pages 26-27).

Tips:

• If your TV has several SCART sockets, please use the SCART sock-

et that is suitable for the video output and the video input.

• If your TV offers a menu to choose the SCART socket, please select

“VCR” as the connection source of this SCART socket.

Problem:

Your screen is empty:

• Many TVs are switched by the DVD recorder to the programme num-

ber for the SCART socket by way of a control signal sent through the

SCART cable. If the TV does not automatically switch to the SCART

socket programme number, manually change to the corresponding

programme number on your TV (please refer to the user’s manual of

your TV).

• Check that the SCART cable is connected from the TV to the “EXT1

TO TV” (SCART-1) socket on the DVD recorder. The socket “EXT2

AUX” (SCART-2) is intended only for additional devices.

HELLO

EXT1 TO TV

Virgin mode

Before using your recorder,

please complete this setup.

1 / 7

AC IN