Operation Manual

12
CyberLink AudioDirector
The graph shows playback time along the top, and the frequency (relative pitch) of
the audio (measured in hertz) along the right. The colors on the graph indicate the
amplitude or strength of the audio at the point in time. The lighter the color, the
louder the audio is at that frequency and time.
Timeline Markers
When editing, restoring, or mixing audio, click to add a timeline marker at the
current position of the timeline slider. Markers are used to mark the positions in
your audio files where you might want to edit the audio file or start an effect from.
In the Mix room, use markers when adding audio clips as they will snap to the
timeline markers.
Adding Timeline Markers
To add a timeline marker, do this:
1. Use the playback controls to find, or drag the timeline slider to the position
where you want the marker, and then click .
2. Input a Description for the new timeline marker, if required.
3. Click on OK to add the new timeline marker.
Note: you can double click on a time marker to edit its properties, if required.
Timeline Zoom
When editing, restoring, or mixing audio on the timeline, use the controls to zoom
in on the audio timeline to make your editing more precise. There are two types of
zooming available: horizontal zoom and vertical zoom.
Note: when using the zoom controls, you can click the button at any to time to
zoom all the way back out for a full view of the audio waveform.
Horizontal Zoom
The horizontal zoom controls let you increase/decrease the time magnification of
the audio in the timeline.