Operation Manual

Editing Audio

Applying Audio Effects

In CyberLink AudioDirector you can choose from a number of default effects and

apply them to your audio files. You can also import custom VST plugin effects that

you downloaded and apply them to your audio.

Note: when you apply effects to audio, they are not applied to the original file until

you produce it in the Produce window. See Producing the Audio for more

information.

Using Dynamic Range Control

Use Dynamic Range Control to adjust the shaping of the dynamics in your audio.

To use dynamic range compression on audio, do this:

1. Select the media file in the library that you want to use dynamic range

compression on.

2. If required, use range selection to select the portion of an audio file you want

to apply the effect to. See Range Selection for more information on selecting

a range of an audio file. If you don't select a range, the effect is applied to the

entire audio clip.

3. Decide whether you want to apply the effect on all the available channels, or

just one channel. See Selecting Channels for Editing for more information on

selecting channels.

4. Click Dynamic Range Control under the Apply Effect section.

5. Use the control sliders as follows:

Note: see Common Dynamic Range Controls below of a description of what each

available slider does in the Dynamic Range Control window.

Limiter: adjust these sliders to aggressively limit high level signals. You can

use the limiter to prevent clipping or distortion.

Compressor: use these sliders to apply more gentle dynamic control to

medium level signals and peaks.

Gate/Expander: use these sliders to boost (expand) the level of soft signals.

Note that the expander can have a ratio greater or less than 1.0. When the

ratio is greater than 1, it is operating as a gate and any signals below the

threshold will be decreased in volume.

6. Use the Output Gain slider to adjust the output gain for the processed