Operation Manual

68
CyberLink M edia Suite
editor, where you can view and save it.
Click OK to close the window.
Copy a Disc or Burn a Disc
Image
The Copy Disc or Burn a Disc Image function allows you to make an exact copy of a
disc. However, you must copy the disc contents onto a blank disc of the same disc
type. The Copy Disc function also allows you to burn disc images.
Note: some discs may not be copied if they are copy-protected or contain errors.
Copying a Disc
The copy disc option allows you to make an exact copy of a disc of any format.
However, you must copy the disc contents onto a blank disc of the same disc type.
(You cannot, for example, copy content from a CD onto a DVD.)
To copy a disc, do this:
1. Select the Copy a Disc or Burn a Disc Image function in the Data & Backup
menu of the CyberLink PowerStarter program window. In the CyberLink
Power2Go new task window, select Copy Disc to open the Copy Disc window.
2. Select your source and target drives.
3. Select a Read speed and Write speed for each disc. The speeds you should
select will depend on the burning drives you are using and the quality of the
discs.
4. Select Ignore reading error if you want CyberLink Power2Go to copy the disc
even if errors are encountered.
5. Select the Copy to hard disk option, if available, to also save a copy of the disc
to your computer’s hard drive.
6. Select Copy whole disc if you want to copy the entire contents of the disc
onto the destination disc.
7. Enter the Number of copies you want to burn.
8. If available, you can use the following options to assist with the burning
process: