Operation Manual

69
Data & Backup
select Perform write simulation if you want CyberLink Power2Go to simulate
the burning process first to ensure the burn will finish successfully.
if available, select Verify recorded data if you want CyberLink Power2Go to
verify that the content was successfully burned to the disc.
if available, select Enable defect management to have CyberLink Power2Go try
to fix any defects on a disc so that content burns correctly.
9. Click Copy to begin the copy and burn process.
10. When burning is complete, select an option in the window that opens:
Click View Log to view the burning log. The log opens in your default TXT
editor, where you can view and save it.
Click OK to close the window.
Burning a Disc Image
A disc image is a file on your computer that is the duplicate of the contents and file
structure of a disc. CyberLink Power2Go lets you burn a disc image to a disc.
To burn a disc image, do this:
1. Select the Copy a Disc or Burn a Disc Image function in the Data & Backup
menu of the CyberLink PowerStarter program window. In the CyberLink
Power2Go new task window, select Burn Disc Image to open the Burn Disc
Image window.
2. Click to select the disc image you want to burn to a disc.
3. Insert your disc and select your drive in the drop-down in the To section.
4. Select a Write speed for burning the disc. The speed you should select will
depend on the burning drive you are using and the quality of the disc.
5. Enter the Number of copies you want to burn.
6. If available, you can use the following options to assist with the burning
process:
select Perform write simulation if you want CyberLink Power2Go to simulate
the burning process first to ensure the burn will finish successfully.