Operation Manual

50
CyberLink Power2Go
Disc name: enter a name for the disc. The disc name appears on a disc player
during playback.
Use the original date and time: select this option to use each file’s original date
and time for the date info used for the files burned on the disc.
Use the current date and time: select this option to use the current date and
time for the date info used for the files burned on the disc.
Use this date and time: select this option to manually enter a specific date and
time in the fields provided for the date info used for the files burned on the
disc.
Configuring Burner Settings
The Burner settings tab displays before burning most of the disc types. On this tab,
configure the settings as follows:
Burner: displays the burner that CyberLink Power2Go will use to burn the
disc.
Write speed: select a write speed from the drop-down list. The speeds that are
available is dependent on the drive installed in your computer.
Copies: enter the number of copies of the disc you want to burn.
Enable buffer underrun protection: select this option to ensure that data is
written to disc without interruption. (An interruption in data can result in an
unusable disc.)
Write simulation before burning: select this option to perform a write
simulation first to verify that your burner can burn to the disc at the selected
speed without encountering any errors.
Note : if you have enabled buffer underrun protection or have previously burned
discs using the current settings, you do not need to run a simulation.
Close disc: select this option to write-protect a disc. Once burned, no further
data can be added to the disc. If you do not select this option, you can create
a multisession disc. See Multisession Discs for more information.
Verify recorded data: select this option if you want CyberLink Power2Go to
verify that the content was successfully burned to the disc. Select Quick
verification to have CyberLink Power2Go quickly verify the correctness of the