Operation Manual

The Basics
49
 The next selection is for snapshots that you have captured from your video
content in the Capture or Trim Modes.
 Snap to Clipboard captures the image onto your Windows' clipboard.
 Snap to Wallpaper (Center) will capture the image, place the image
centered on your desktop in its original size, and save it automatically in
your default Windows' System folder.
 Snap to Wallpaper (Tile) will capture the image, place the image on your
desktop in its original size following a tile format, and save it
automatically in your default Windows' System folder.
 Snap to File will capture the image directly into a folder you have
selected. For this selection, you may input the file name and select a file
format form the drop-down box.
 Click DV Parameters to set up the buffer parameters for your DV camcorder.
 All DV camcorders’ mechanisms and the time it takes for the tape to start
rolling differ in seconds. Thus, if there is no buffer time, batch capturing
will begin too early. Enter the time you would like to buffer your DV tape
so that batch capturing will coincide with it. The tape will begin playing
during this buffer time and after it has elapsed, capturing takes place.
 When writing to tape, all DV camcorders’ mechanisms and the time it
takes for the tape to start rolling differ in seconds. Setting an adequate
buffer time for sending video stream to your tape eliminates these
differences so that when the tape begins writing, it coincides with the
beginning of the video stream feed. Click OK.
Click OK or another tab to set more preferences.