Operation Manual

Producing Your Movie
145
7. Locate the position at which you would like to begin writing to
tape. You may do this in one of the following ways:
• Use the playback buttons.
• Drag the time slider.
• Enter a timecode in the timecode box.
8. Your produced movie file appears in a list in the window.
• Click to add new files to the file list. Select a file and click
to remove it from the file list.
• Select a file then click to bring it closer to the beginning
of your movie when writing to tape. Click to move it
toward the end.
• To ensure that all of your video clips have the same
interlacing format, click Scan source video clips and set field
order.
Note: This is an extremely important step to take before producing
your final movie, as it can drastically affect final video quality!
9. Click Start. A message appears asking you to ensure your tape is
at correct location and not write-protected. (Writing back to tape
overwrite any content currently on the tape at that position.)
10. Click Yes. Writing begins.
• Click Abort to stop.
• If successful, a confirmation message appears.
11. Click OK.