Operation Manual

CyberLink PowerDirector 5
102
Perform Magic Clean on an Audio Clip
The Magic Clean tool is ideal for use with audio clips that were
recorded outdoors, in a room with poor acoustics - even in a car or
other noisy location. The Magic Clean tool uses CLNR (CyberLink
Noise Reduction) technology to improve output audio.
To perform Magic Clean on an audio clip, select the clip in the
timeline, then click . The Magic Clean pane opens.
The following options are available:
• Apply CyberLink Noise Reduction to remove audio noise:
Check this option to enable Magic Clean for audio.
• Noise Type: Filters out noise from the audio track. Drag the
slider to remove more or less noise.
• Machinery noise: Applies a specific noise reduction
technology to reduce background noise created by
recording outside.
• Wind noise: Applies a specific noise reduction technology
to filter out wind noise.
• Clicking noise: Applies a specific noise reduction
technology to filter out clicking noise.
• Apply to all clips: Check this option to apply your changes to
all the audio clips in the project.